| Long years of experience.
|
 |
In 1957, the first prototype of fibreglass-reinforced
polyester cooling tower was built at the factory in Lindau (Germany). Since
then, our objective has been to achieve
the best performance and optimum quality.
In this way our clients benefit from
the best product, in both technology
and quality.
|
| Development and testing. |
|
|
All our products, new models and special
constructions are developed by our
technical office.
Our development is aimed at optimising
the power, electrical energy consumption
and noise levels.
All these factors are carefully assessed
during the tests carried out before
incorporating new models into our
range of products
|
| Long lasting. Perfect
finish. |
|
All the materials used in building the
towers and, in particular, the polyester
casings, are characterised by their
strength and long duration even under
the most aggressive conditions, as proven
by the fact that some of these towers
are still in service after 20 years
without alteration to the materials.
The picture shows the comparison between
the fibreglass-reinforced polyester
casings (corrosionproof) and those made
of sheet metal (corroded). The high-quality
finish in the factory prevents alignment
problems and allows quick assembly on
site
|
| A suitable model for
each need. |
|
|
A suitable model is determined for
each performance, within our extensive
standard range, to meet even the most
demanding needs.
Due to plant measurements, our equipment,
most of it square-shaped, can be installed
in reduced spaces.
When a very precise adjustment of
the cooling capacity is required,
two-speed motors can be installed,
which also achieve considerable savings
in electrical consumption.
If different cooling capacities are
needed, the usual procedure is to
install as many in-line modules as
steps required.
The standard blue colour of the EWK
towers can be modified, on client
request, to best match the appearance
of the buildings.
|
| Assembly on site.
Large units. |
|
Due to the pre-assembly at the factory,
the assembly time on site is reduced
to the minimum. The possibility also
exists of sending a specialised technician
to supervise the assembly process and
start-up.
|
| Easy maintenance.
|
|
All our equipment is extremely easy
to clean and to maintain. The replacement
of the components is simply and quickly
done, as shown in the picture
|
| Technical service. |
|
Our technical service is at your disposal
to supply any component in a short time,
and to send a service technician to
do the repair work or servicing as required.
|
| Low noise level. |
|
|
Even though the EWK towers and condensers
have a low noise level, in some critical
cases, an exhaust silencer can be
fitted to reduce the noise level even
further.
For living areas in which the minimum
noise level is a must, it is possible
to install EWK centrifugal cooling
towers.
|
About us 
